White Wall Grout

Thompsons White Wall Grout will leave a brilliant white finish to all wall tiles, making it ideal for use in kitchens and bathrooms

Conforms to BS EN 13888 Class CG1

White Wall Grout 3,5kg

Water resistant wall tile grout

1-4mm joint widths

Suitable for all types of tiles

Domestic & commercial use

Suitable for use with:

all wall tiles

Mix Ratio - 5kg per 800ml of water

Stockists near you

Weather forecast

Please share your location to receive an accurate weather forecast

Today

Tomorrow

Come rain or shine, Thompson's got it covered

Drying Time

don't wet for 24 hourS

Sizes

3KG

Colours

white

Coverage

m2 / litre

Sizes

3KG

Colours

white

Before grouting the tile joint, ensure the tile adhesive has set and dried, and that the tiles are firmly bonded to the substrate

Under normal circumstances, standard set adhesive should be left for 24 hours and rapid set adhesive 3 hours before grouting commences

Ensure the tile joints are clean, free of dust and other contaminants

Excess adhesive should be removed from the joints whilst still fresh

WARNING: Coloured grouts can cause scratching or surface discolouration to certain types of tiles. We recommend testing the grout on a spare tile before grouting the tiled area. Where necessary, apply a protective treatment to the surface to ensure the grout does not penetrate the porous surface of the tiles. Avoid covering the tile in grout and work the grout into the joint covering as little of the tile as possible.

Mixing

It is recommended to use a low speed mechanical mixer

Gradually add Thompson's White Wall Grout to clean water in a clean mixing vessel and mix thoroughly until a smooth, creamy, consistent mortar is achieved

After mixing, allow the mix to stand for 2-3 minutes and briefly re-stir before use, add more powder at this stage if required. As a guide for powder to water ratio, 3.5kg of powder requires approximately 1.1L of water

Once mixed, the grout remains workable for approximately 30 minutes at 20⁰C; however this time will be extended by lower temperatures and shortened by higher temperatures

Do not add water after initial mixing as this will weaken the mix and could lead to cracking. It may also cause discolouration of the grout

Application

Using a rubber squeegee or a rubber float, work the mixed grout thoroughly into the joints ensuring they are completely filled

Excess grout should be removed as work proceeds by moving the rubber float diagonally across the tiles to prevent removal of grout within the joints

For a neater finish, smooth joints with a suitable round headed tool of suitable size and shape

Clean excess grout from the tiles and joints with a damp cloth or sponge as soon as possible as set grout will prove difficult to remove later

Any dry film can be removed by polishing off with a clean, dry cloth once the grout has hardened in the joint.

All materials used during application such as tools and cloths must be clean and free from contaminants likely to cause staining of the grout

Clean tools immediately after use with clean water