Rubberised Bitumen Emulsion

Thompsons Rubberised Bitumen Emulsion can be used on walls and floors to prevent water ingress and damp, leaving a water tight repair.

Rubberised Bitumen Emulsion 2-5L

Prevents water ingress and dampness from the ground

For use on walls & floors

Provides protection against corrosion of pipes and structural steelwork

Suitable for use on:

walls & floors

Stockists near you

Weather forecast

Please share your location to receive an accurate weather forecast

Today

Tomorrow

Come rain or shine, Thompson's got it covered

Drying Time

48 HOURS

Before plastering

Coverage

2-4m2 / litre

Sizes

2 5_5

Colours

Black

Coverage

2-4m2 / litre

Sizes

2 5_5

Colours

Black

Surfaces should be clean, dry and free from oil, dirt, dust and debris.

This product can be applied to damp but not water logged surfaces.

Porous and dry surfaces should be dampened with a clean cold water to assist application of the product.

Allow good ventilation in confined areas.

Stir thoroughly before use.

Apply by brush.

Can be applied to surfaces with poor keying properties to aid plastering.

When preparing surfaces for plastering, surfaces should be coated with two thin layers of Thompson’s Rubberised Bitumen Emulsion at 4.5m2 per litre. The first coat should be allowed to fully dry before the second is applied.


Whilst the second coat is still tacky it should be blinded with clean, sharp sand and allowed to dry for 48 hours before plastering

Tools should be cleaned in warm water before the product has dried

If the product has set, use a scraper to remove as much bitumen as possible and then remove the remaining paint with white spirit

Minor spillages should be wiped off the surface before the product has set

Major spillages should be mopped up immediately with an absorbent material, such as sand, and disposed of in accordance with regulations